These were just 10 quick reasons off the top of my head.

May 20, tree md said: The prussic knot is fine to work off of, just use a lanyard in combination with your TIP when making cuts with the saw and you should be fine. I would stick to a handsaw though if you don't have any experience with a chainsaw in the tree. You'll keep yourself out of trouble that way. Jun 02, Procedures: How To Rope down a Tree Limb Step 1: Positioning the ladder.

Sarah Moore has been a writer, editor and blogger since

At first, set an extension ladder on a tree as it confirms the secure position. Select Step 2: Cutting the branches. Now, you need a echo pruning saw for removing the small Estimated Reading Time: 5 mins. Sep 01, Cut discs of ½-inch to an inch in thickness from hardwood branches for the shims.

Do not taper the discs, as that will make them weak and liable to break in the notch. Using two wedges, side by side, drive one home so that there is a gap between the stem and the top of the other wedge.

When surrounded by rope, wire or another thin, binding material, a tree continues to grow outward around the obstruction. Eventually, the material can become embedded in all or part of the tree.

Jun 03, On each of the leaves on the stem, cut off half of the leaf. Dip the end of the cutting to be rooted in rooting hormone; Put the end to be rooted into a small pot of damp soiless mix.

Headed back tomorrow up Griffin Creek with a come-along to encourage it to fall without killing me.

Wrap the whole pot and cutting in a plastic bag. Tie off the top but make sure the plastic is not touching the cutting.